Wilson, WI Heating Cooling Plumbing
Free Premium Indoor Air Quality Package
with Purchase of Furnace & AC
Includes Merv 16 5" media cabinent and ApcoX Premium UV-light. Cannot be combined with any other offers. Must present coupon at time of service. Not valid on previously completed work.
Highly Rated
Satisfaction Guaranteed
Family Owned
Friendly Technicians
When you get your heating, air conditioning, and plumbing service through us, you can be assured that it is done properly. Check out our reviews below to read what your neighbors are saying about our heat, AC, and plumber services in Wilson, WI.
Recent Jobs and Reviews in Wilson, WI
Job Locations and Reviews
Trent L.
Diagnosed homeowner's no-heat complaint and found a non-functioning smart thermostat despite proper power supply to the unit. Determined the thermostat control board was failing and installed a new S40 thermostat. System is now operating properly with both zones functioning as designed on the 2016 Lennox natural gas furnace.
Wilson, WI 54027
Mike A.
Responded to call for RS12-4 condensing boiler (LP, 4 years old) displaying overheating code and shutting down after only 10 seconds of operation. Inspection revealed blocked combustion air intake with debris and a bumblebee obstructing proper airflow. Preliminary diagnosis indicates possible scaling on heat exchanger per manufacturer's technical information. Unit was powered off for safety as heat exchanger temperature was excessively high. Return visit scheduled to perform full diagnosis with manufacturer technical support and determine if descaling procedure is required to restore proper operation.
Wilson, WI 54027
Ben W.
Diagnosed and repaired no heat condition on recently installed furnace. Found two issues: improperly pitched exhaust piping was corrected by cutting and re-gluing with proper slope back to unit, and cleared blockage in condensate drain system that had caused inducer motor to fill with water. Restored proper drainage and verified normal heating operation after repairs.
Wilson, WI 54027
Ben W.
Responded to a no-heat call for an 80's era furnace blowing cold air. Upon arrival, system was locked out due to overheating with supply air temperatures approaching 150°. Diagnosed severely restricted airflow with almost 1" WC static pressure on return side and minimal static on supply side. Found only two functional returns throughout home, multiple closed vents, and heavy dust accumulation in ductwork. Reset system, opened basement vents, verified all supplies were open, and inspected burners (found crusty). Noted system using cooling wire on blower for heating due to furnace running hot. Verified proper gas pressure, correct orifice, and functioning blower capacitor.
Wilson, WI 54027
Ben W.
Performed standard oil furnace tune-up including nozzle replacement and filter change. Inspected capacitor and found it in working condition. Identified and addressed oil leak at filter housing by replacing filter and gaskets, with no residual leakage observed after repair. Advised customer that oil tank gauge readings appear inaccurate, though customer is aware of current oil levels.
Wilson, WI 54027
Roger M.
Completed annual furnace tune-up on 9-year-old system as part of 2x yearly recurring service agreement. Performed comprehensive inspection of heating components including examination of evaporator coil condition and electrical connections. All systems functioning properly with no issues identified.
Wilson, WI 54027
Dan S.
Diagnosed heating system failure in white boiler with no flow to house. Identified multiple issues including a stuck floor control valve, faulty pressure gauge, and possibly malfunctioning ball valve near circulator pump. Replaced pressure/temperature gauge, freed up control valve to restore water flow, and installed relief valve. System was properly pressurized and bled out; however, circulation issues persisted despite pump appearing operational. Recommended expansion tank replacement and auto fill system upgrade from filter trial to conventional configuration. Scheduled follow-up service with boiler specialist for further diagnosis.
Wilson, WI 54027
Dan S.
Responded to a return service call to install a relief valve on customer's boiler system. Successfully installed the relief valve and performed a complete system bleed, but noted the boiler was still overheating due to poor water circulation. Inspection revealed the circulator pump was operational but ineffective, with a potentially defective ball valve above the pump that may have a broken shaft preventing proper opening/closing. Recommended further diagnosis by a boiler specialist.
Wilson, WI 54027
Logan P.
Responded to service call for a leaking piercing valve on a 3/8" hot water line that was failing to shut off after HVAC contractor removed an old humidifier. Removed the defective piercing valve and repaired the damaged section of copper piping using a SharkBite coupling to restore proper system operation.
Wilson, WI 54027
Trent L.
Diagnosed 20-year-old boiler system not producing heat due to overheating from insufficient water circulation and a leaking relief valve. Opted against adding water to the hot cast iron boiler to prevent damage. Ordered new relief valve and recommended system bleeding to restore proper circulation, with contingency plan for possible circulator pump replacement if needed.
Wilson, WI 54027
Gary L.
Diagnosed 22-year-old York furnace with no heat issue. Found inducer draft motor seized, running hot, and collector box cracked. Recommended replacement of both draft inducer motor and collector box due to age and condition of unit.
Wilson, WI 54027
Mike A.
Performed furnace burner assembly replacement. Installed new burners after identifying corrosion and rust on the existing assembly. Completed comprehensive verification of inlet gas pressure and both stages, checked terminations, and conducted performance testing to ensure proper burner operation.
Wilson, WI 54027
Beca R.
Diagnosed furnace no-heat issue caused by malfunctioning burners. Performed temporary cleaning and manually assisted ignition to restore heating function. Ordered replacement burner assembly as existing components were not reliably self-igniting.
Wilson, WI 54027
Beca R.
Performed annual furnace tune-up on 10-year-old FRP unit. Conducted comprehensive maintenance including flame sensor cleaning, electrical component testing, filter replacement, and condensate hose verification. Visual inspection of heat exchanger showed no issues. All systems functioning within manufacturer specifications.
Wilson, WI 54027
Beca R.
Completed biannual furnace tune-up maintenance on two Amana heating units. Services performed include cleaning flame sensor, electrical testing, verification of clear drain lines, and combustion analysis (measured readings: CO 25P, CO2 9.0%, XAIR 52.8%). All systems functioning properly with parameters within specifications. Customer's filter was recently replaced and still in good condition.
Wilson, WI 54027
Beca R.
Performed scheduled bi-annual furnace maintenance on two Amana units. Services included cleaning flame sensor, testing electrical components, verifying clear drain lines, and conducting combustion analysis (CO 25P, CO2 9.0%, XAIR 52.8%) - all readings within specifications. Filter was relatively new and did not require replacement. Both furnaces are operating properly with no issues detected.
Wilson, WI 54027
Ben W.
Performed scheduled semi-annual maintenance on furnace system. Diagnosed and resolved issue with non-responsive garage heater thermostat through inspection and reinstallation. Installed customer-provided replacement thermostat in garage. Completed comprehensive furnace maintenance including verification of proper temperature rise, drain cleaning, and component inspection. Recommended duct cleaning service due to extended period since last cleaning, which was subsequently scheduled.
Wilson, WI 54027
David B.
Friends and family inspection home was in beautiful condition. Everything looked great.
Wilson, WI 54027
Greg M.
I was called to a home to repair an electrical issue. The homeowner reported that the lights in their home were flickering and the power was intermittently going out. I arrived at the house and began to investigate the problem. I found that the electrical panel was overloaded and needed to be replaced. I replaced the panel and tested the system to ensure that it was working properly. The homeowner was very grateful for my help and was relieved that the problem was resolved.
Wilson, WI 54027
Dean M.
Service a trane gas furnace in Wilson
Wilson, WI 54027
“Mark was very pleasant to work with! He was on time and took care of my plumbing needs efficiently and effectively. I would definitely use him again for any plumbing issues I may have. I have been using Hurlburt for all of my heating, plumbing, and electrical needs and have always been satisfied!”
Alison A.
“Great service! Professionals starting from the first person I spoke to on the phone and finalizing with the person who finished the installation and cleaned up after. Staff explained everything well. Highly recommended!!!”
Jessica F.
"Outstanding service as always! Hurlburt goes above and beyond for their customers. We got scheduled right away, and Shawn did a great job. I will continue to use these guys for everything!!!"
Nicole T.
"Our technician Mike was just awesome. Took the time to show me what he was doing and explained why he was doing it. Gave me an honest evaluation of my situation. You can’t go wrong with Hurlburt and the work ethics of the employees."
Jean C.
Trevor came to service our AC unit. Very happy with his work. Trevor was friendly and knowledgeable, and got our issue fixed quickly. Hurlburt Heating and Plumbing is a great company to work with."
Debbie L.
"Hurlburt has helped us out with both plumbing and HVAC services in the past and have always done a great job. All their technicians, especially Mark, have been kind, professional, and quick with service!"
Sara N.
©2026 Hurlburt. All Rights Reserved.
Privacy Policy | Terms and
Conditions
This site is protected by reCAPTCHA and the Google Privacy Policy and Google Terms of Service apply.
