When you get your heating, air conditioning, and plumbing service through us, you can be assured that it is done properly. Check out our reviews below to read what your neighbors are saying about our heat, AC, and plumber services in Stockholm, WI.
Responded to no cooling complaint on residential air conditioning system. Upon arrival, found condenser fan motor humming but not starting, requiring manual assistance to initiate operation. Diagnosed failed dual run capacitor exhibiting visible bulging, indicating internal failure. Removed and replaced defective capacitor with proper rated replacement. Verified condenser fan motor and compressor started properly without assistance. Checked system operation and confirmed unit cooling effectively with normal amperage draws on all components.
Completed comprehensive AC tune-up on recently installed system as part of recurring maintenance agreement. Performed full system inspection including air filter check, condensate drain verification, and temperature drop analysis—all within normal parameters. Cleaned condenser coils, inspected outdoor unit components, and confirmed proper operation of all mechanical and electrical systems with satisfactory performance.
Performed seasonal maintenance and switchover on geothermal heating and cooling system. Switched thermostat from heating to cooling mode, adjusted Ranco control to 47°F setpoint, and verified proper operation of all components including pressures and temperatures on geothermal loop. Monitored system through complete cycle to confirm proper shutdown at setpoint and verified air handler fan operation with thermostat control. Deactivated boiler for summer season. System operational and ready for cooling season.
Responded to water leak in mechanical room originating from well system's pressure control. Upon arrival, found variable speed pump manifold cracked and leaking, with pump already shut off to prevent further water discharge. Documented existing plumbing configuration showing blue pressure tank, brass piping with visible moisture accumulation, and gray pump control unit with connected PVC and shutoff valves. Provided estimate for manifold replacement to restore system functionality.
Responded to no heat call for oil furnace stuck at 51°F. Diagnosed air-locked oil pump due to fuel depletion. Successfully bled air from oil line, restored proper operation, and verified system functionality through multiple heating cycles.
Arrived after 12pm as requested to complete shower installation. Successfully installed shower trim components and connected all necessary plumbing fixtures through existing blue-green tiled surface. Verified proper water flow and functionality of the newly installed shower system.
Completed plumbing inspection to evaluate feasibility of converting small bedroom into shower space. Took detailed measurements and photos of the area to prepare comprehensive estimates for the conversion project. Will provide detailed recommendations and cost projections for the bathroom addition as requested.
Responded to no heat call for 25-year-old Goodman furnace. Diagnosed failed blower motor as the root cause. Replaced blower motor and verified proper system operation. Customer declined new equipment options, requesting repair only.
Diagnosed tank water heater displaying 3 green lights with no hot water output. Inspection revealed failed blower motor assembly as the root cause. Provided customer with replacement options for a new water heater system.
Installed stamped steel return air grill with damper for upstairs air handler to improve circulation in area experiencing overheating issues. Verified proper installation of filter box (20x20x1) with appropriate ductwork connections to enhance airflow distribution.
Responded to a no-heat service call for an older boiler system. Upon inspection, discovered a condensate cup that wasn't properly tightened, causing ongoing leakage since installation. Tightened the component to stop the active leak, cleaned the affected floor area, and noted some black organic growth on the back wall which customer acknowledged. Advised customer to periodically check the area for any future leakage issues.
Responded to emergency water leak caused by broken shower handle. Inspected the Moen shower valve assembly and identified a failed cartridge as the source of the leak. Successfully replaced the defective Moen cartridge, restored proper functionality to the shower control, and verified complete resolution of the leak. Water service to home was restored after repair verification.
Responded to no-heat call on 3-year old HVAC system. Customer reported circulation motor issues with diagnostic flash codes 1+2. Upon inspection, determined that customer was not allowing for the system's required 90-second purge cycle before fan operation. Demonstrated proper operation to customer, verified multiple successful heating cycles, and confirmed system is functioning as designed with no repairs needed.
Performed routine maintenance on a 4-5 year old LP furnace in mobile home. Conducted comprehensive inspection including heat exchanger evaluation, operational testing of all components, and standard tune-up procedures. All systems functioning properly with no defects or issues identified.
Responded to emergency service call for a broken pipe in garage causing water leakage. Diagnosed cracked ball valve that had failed due to freezing conditions. Successfully replaced damaged ball valve and adjacent pipe section, restoring proper water flow and preventing further leakage into the garage area. System tested and confirmed operational.
Successfully completed a repair by replacing the combustion inducer assembly and all four main burners per approved estimate. System was test run for 30 minutes following installation to verify proper operation and performance.
Performed fall maintenance and winter startup on geothermal system, verifying proper operation. Identified and corrected valve settings on Munchkin boiler, adding written instructions directly on the unit for client reference. Added water to the load side as needed and sold replacement register to be installed on a future visit.
Responded to no heat complaint for 17-year-old LP system serving mixed-use building. Diagnosed tripped limit switch on inducer caused by recently installed filter after previous filter was heavily clogged. Reset limit switch, performed heat exchanger inspection, and restored heat operation. Noted significant rust on burners and concerning inducer motor noise; provided customer with replacement options for these degraded components.
Responded to service call at customer's bunk house for a missing plug on the side of the Goodman furnace, which was likely dislodged during previous gas valve replacement service. Located and reinstalled the missing furnace plug to restore proper operation and system integrity.
Diagnosed 32-year-old oil boiler that was not firing. Investigation revealed a wire had become disconnected from the electrode, likely from previous service interaction when nozzle work was performed. Reconnected the wire securely to the electrode and verified proper system operation. System now functioning normally.
©2026 Hurlburt. All Rights Reserved.
Privacy Policy | Terms and
Conditions
This site is protected by reCAPTCHA and the Google Privacy Policy and Google Terms of Service apply.